The main > Repair> Vesiculate panel the hands

Vesiculate panel the hands

The air and vesiculate panel can become the center of your interior. It will attract a look of any person. Slowly rising bubbles, illumination. Such panels can perfectly fit into any interior of office or the apartment. Because of high cost of a product the panel can buy not everyone. But it can be made most. InfoHow.net will tell you as the vesiculate panel the hands becomes.

The vesiculate panel, or air falls, it is possible to make most. But here it is necessary to tinker a little. It is best of all to be trained at first on smaller designs that you could understand physics of air bubbles. As they rise that is necessary for their dispersion etc. Also certain materials will be necessary for you.

So, to make the vesiculate panel the hands, it will be required to you:

cellular plexiglas
silent compressor
air vinyl hose
spray
the backpressure valve (if the compressor settles down in the bottom of the panel)
illumination
glue

The design of the air and vesiculate panel is not anything difficult. You will have a podium on which the panel, the panel and a cover which will close all design from hit in it of dust or other dirt will keep.

Also in advance think of illumination. Various colors of illumination will create beautiful lighting effects. But again it is necessary to think over, which illumination you want to use. Light-emitting diodes, of course, are very economic. But they illuminate water only on 30 cm. Therefore most often use LED illumination — neon bulbs. Do not forget about the RGB controler for management of illumination. Illumination it is possible to arrange from below, on each side or from above panels.

How to make the vesiculate panel

So, in the lower part, i.e. a podium of the air and vesiculate panel, it is necessary to install system of aeration, the compressor, the backpressure valve, the power unit, the RGB controler and the module of illumination. If you have the compressor at the top of the panel, the backpressure valve will not be required to you. At switching off of the compressor water will not fall on a tube, and will remain at the level.

The design should be built on the pallet from plexiglas. Through glass illumination will be visible. It is also necessary to leave a little water that the water column constantly kept in the pallet. From the compressor it is necessary to start up a tube from which vials of air will get to openings of cellular glass. That vials of air did not accumulate in one heap, it is necessary to use an acrylic spray in which openings are done. In each tube you should adjust the outlet. Thanks to adjustment of openings it will be possible to create diameter of air bubbles.

Also do not forget to think of where there will be at you a tank via which you will add water. Water will evaporate anyway after a while, after all the vesiculate panel will not be hermetically closed. You can arrange the tank for addition of water both from above, and from below panels. It will be also quite good to make the valve for water descent if it has to be changed.

It is worth remembering that production of the vesiculate panel — is exact and long process. It is necessary to consider many nuances: as you will bring tubes with sprays, sealing of connections, illumination and water which will be in the panel. In the panel it is necessary to fill in the distilled water, sometimes add a small amount of glycerin to it.

As you can see, the vesiculate panel the hands — it is difficult, but is much cheaper, than purchased. If you feel in yourself forces to make independently air and vesiculate panel, can get down safely to business.