How to glue vinyl wall-paper?

It is possible to glue vinyl wall-paper only on a dry and equal surface. Therefore at first it is necessary to clear walls of old coverings (wall-paper, paint, plaster), to putty all cracks and carefully to level a surface.

Before a pokleyka of wall-paper of a wall ground a primer of deep penetration or special glue for vinyl wall-paper and process the fungicide structure preventing emergence of a mold under wall-paper. It is possible to glue vinyl wall-paper only on completely dried wall!

Wall-paper needs to be cut on strips, having left an allowance on length of 10 cm. If on wall-paper there is a drawing, pick up the next panels so that the pattern as much as possible coincided. Before cutting of wall-paper check that at all rolls a series coincided — wall-paper from different series can differ with a shade slightly.

It is necessary to glue vinyl wall-paper end-to-end. But such pokleyka of wall-paper has the nuances: after drying vinyl wall-paper can "shrivel", and between panels there will be gaps. Therefore apply less glue on vinyl wall-paper, than on paper, and do not stretch them on width when gluing at all. Wall-paper not the pallet, and the special rubber roller or a brush with a short bristle drives into the corner, especially carefully ironing seams.

For the same reason wall-paper needs to be glued indoors without drafts — when drying they "are whimsical", do not suffer differences of humidity and temperatures. Therefore by no means it is impossible to open windows or to turn on the conditioner before full drying of wall-paper.

Clay for vinyl wall-paper needs to part according to the instruction, usually it needs to stand 5-10 minutes for swelling. Glue is applied or only on a wall, or and on wall-paper — it has to be specified a wall in the instruction on a roll with vinyl wall-paper. It depends on a basis: on wall-paper with a paper basis it is necessary to apply glue, on wall-paper with flizelinovy — no.

If in apply glue on vinyl wall-paper on a paper basis, watch that edges were not dry. Wall-paper on a paper basis does not glue at once after putting glue. They are put a basis to a basis that glue bulked up (time of swelling depends on density of material and it is specified on packing). That seams were pure, and wall-paper looked faultlessly, the layer of glue has to be thick and uniform, and swelling time — identical to all panels.

It is necessary to glue vinyl wall-paper together. One person climbs on a step-ladder and puts the upper edge of wall-paper to a wall. The second costs on a floor and supports bottom edge of a panel, accurately leveling a wallpaper strip on a vertical (for this purpose it is possible to draw on a wall a vertical line in advance to be guided on it).

Then it is necessary to press slightly wall-paper to the basis and to force out vials of air by means of a brush: from top to down and from the center to edges. If at edge of wall-paper glue acts, it needs to be wiped at once a pure rag. It is important to watch that glue did not get on the face of wall-paper.

Surplus of vinyl wall-paper under a ceiling and near a plinth needs to be cut off on a ruler sharply ground knife. If an edge stupid, it rumples and tear wall-paper. The bottom edge of wall-paper is bent under a plinth on 5 mm (better if you remove a plinth before a pokleyka, and then will put into place).

Regarding sockets and switches — they are disconnected before work, removed, glue wall-paper directly over openings, after drying cut out the necessary sites of wall-paper and fasten sockets and switches into place.

But to glue vinyl wall-paper independently not so simply — it is better to attract after all to it professionals which all will make top-level. And whether you had to glue vinyl wall-paper? Whether you are satisfied with result?