- The review of the best monopod for a selfa: we choose a functional selfi-stick
- Games for two: the best way to spend time together
- How to connect a selfi-stick to the smartphone: instruction and councils
- How to clean scratches from phone
- How to stitch phone
- How to stitch the modem of MTS
- How to stitch the modem Megafon
- Royal delicacy: gentle boiled pork in house conditions
- You will lick fingers: tasty chicken thighs
- It is useful and quickly: the most tasty recipes of tvorozhnik
- The most delicate charm: recipes of tasty chocolate glaze for a pie
- The main guest on a table: the best recipes of home-made bread on ferment
- Unusual seasoning: marinated capers and recipes on their basis
- Our food: the best recipes of Russian cabbage soup from sauerkraut
- How to prepare a sturgeon and a sterlet in an oven entirely: recipes of original dishes with a photo
- The best toasts on birthday in verses and prose
- The most cheerful and cool toasts in verses and prose

How to turn on phone without accumulator |
Without use of the battery it is possible to activate practically any phone. In what cases it becomes necessary? There are different emergency situations when the battery is lost, and important data remained, or, for example, if phone is part of a chain of the security alarm system or the listening system. Operation of phone without accumulatorWhether it is possible to turn on phone without accumulator? There is an opinion, what for this purpose it is enough to put of it on charging then it is possible to include, however it not so. The ordinary device for charging assumes work with the battery where it at first accumulates, and then gives current. Power supply of the device directly from charging is impossible: as current is too small, tension will fall at once to a zero indicator as soon as you try "to wake" your phone. To start the device, it is necessary to make independently or to buy the stabilizing power unit which develops constant tension 3,7B with the maximum loading of current no more than 2 And. The necessary tension should not be above an admissible indicator, even at the moments of inclusion/switching off and differences of loading at all. Pay attention that the power unit was protected from an overstrain in case of malfunction, and also had prevention in case of short circuit. How to turn on phone without accumulator? The instruction on turning on of phone without accumulator:
It is important to remember that in case of loss of tension or a detachment of contact, phone will instantly be switched-off. If the device is part of the security alarm system, it is necessary to take care of that it was equipped with the block of uninterrupted food which has to be reliably protected from temperature fluctuations. Council: instead of the power unit it is possible to make the adjustable stabilizer, and to stretch tension, for example, from the computer. Many old models of phones (namely such are most often used for a call-back in the security purposes), request in addition connection of the resistor, and to some devices to four-contact accumulators happens it is necessary and on two resistors. Some models are equipped with system of reading of information from the chip which happens built in the battery. For example, food from the Siemens accumulator is removed on extreme plugs. Between them information contacts which allow phone to identify the battery are removed: NiMH or LiIon. These contacts are connected, as a rule, in front of the last plug to "minus" through 20 kOhm. Such resistor is the thermal sensor during start of the accumulator and is in the battery. It is necessary for its connection:
Apparently phone can be turned on and without accumulator, only some adaptations and knowledge from this article for this purpose will be necessary. |
Read also on our site: Mobile operating systems to read further![]() |
<How to install the navigator | How to restore the accumulator> |